HOME  |  PROFILE  |  STAFF  |  TESTIMONIALS  |  CONTACT  |  FACILITY

ONLINE ONLY
METAL FABRICATING SHOP

RETIREMENT AUCTION
SDL AGRA LTD.
Margo, Sk


BIDDING OPENS
Tuesday December 4th @ 8:00 am
BEGINS CLOSING
Tuesday December 11th @ 8:00 am

30For more information please call Dale Redman @ 306-272-8383

PLEASE CLICK THE "BSA ONLINE AUCTIONS" LOGO TO
REGISTER AND BID ON THIS AUCTION!!

DON'T FORGET, BIDDING CLOSES TOMORROW BEGINNING AT 8:00 AM

BRUCE SCHAPANSKY AUCTIONEERS WILL HAVE A REPRESENTATIVE ON SITE FOR PAYMENTS WEDNESDAY DECEMBER 12th ONLY FROM 9:00 AM TIL 5:00 PM. PAYMENTS MAY ALSO BE MADE IN TISDALE OR BY PHONE WITH VISA & MASTERCARD OR BY E-TRANSFER ETC.

 

 

BUILDINGS:

  • Main welding shop and main bay building, 58’x200’, former school building w/ 31’x42’ wood construction extension, metal roof, not insulated, wired, 19’ high, 25’5”x19’ hyd swing-out door, main manufacturing plant area 58’x77’x18’ high, 16’ high x 27’ wide overhead door, office and parts room area between 2 big buildings, 600 amp service, Physical address is 420 Eva Street, Margo Sk "HIGH BID SUBJECT TO OWNER CONFIRMATION"
  • 8’x10’ wood construction w/ metal exterior storage building, metal roof, walk-in door, wood floor and skids

  • 20.5’x11’ wood construction steel-clad storage building, w/ wood floor on skids, 52” doorway w/ double doors

  • 20’x24’ OSB wood construction storage shed, w/ metal roof, wood floor, w/ shelving, steel and expended metal, 4’x8’ deck and steps
 

HOUSE:

  • Approx 37’ x 32’ 1 level bungalow, w/ attached 32’ x 32’ garage, 9’ wide x 10’ high overhead doors, 12’ walls, house is 1184sqft, cathedral ceiling in living room, cedar int, open concept, 2 bdrm, laundry/furnace room, dirt cellar, fridge, washer, deep freeze & office desk included, 1 bathroom w/ shower and tub, garage is 2 x 6 construction, house is 2 x 4 construction, large fenced backyard, house sitting on 2 lots, metal roof on house and garage, vinyl siding , insulated and wired garage, floor in garage is cement, garage is 3/8s per plywood lined, Physical location 123 3rd ave east, "HIGH BID SUBJECT TO OWNER CONFIRMATION"
 

HIGHWAY TRUCK:

  • 2005 Mack CHN613, w/ Mack D eng., 18 spd trans., 40,000lb rears, air ride suspension, 60” sleeper, dual aluminum saddle tanks, polished aluminum rims, air slide fifth, aluminum chain box headache rack, beacon lights, 11R22.5 tires, SN 1M1AJ07Y85N001601
 

TRAILERS:

  • 2018 Tecumseh 53’ drop-deck trailer, w/ triple axle, crank-down dollies, beaver tail w/ flip-out ramps, 255/70R22.5 tires, air ride suspension, sliding winches, SN 2J9W7A1F7KK001053

  • SDL single axle utility trailer, w/ ball hitch, 80”x12’ steel w/ wood deck, 17’ overall, ST205/75R15 radial tires, 36”x30”x80” steel storage box

  • 1982 Douglas grain bin trailer, w/ self-contained hyd system w/ Honda motor, tandem axle, single wheels, ST235/85R16 tires, dual cradle, 1 stationary cradle, 1 manual move cradle, stabilizer jacks, 2 – 4000lb axles, SN 2684BH1630D2
 

LIGHT TRUCKS:
  • 2010 Ford F150 SL extended cab, short box 4x4, w/ 5.4L gas eng., auto trans., cloth seats, hidden hitch, radial tires

  • 2008 Ford F250 Superduty XLT 4x4 off-road, w/ extended cab, 5.4L gas eng., auto trans., 360,000kms, cloth seats, full load, pilot lights and frame, HD hidden hitch, radial tires
 

FORKLIFT:

  • 2005 Lift King LK6M42, 6000lb capacity, 21’ lift, 4WD, shuttle shift, 16.9R24 front tires, 14-17.5 rear tires, hyd side shift, *weak brakes, SN LT1337 "CAVEAT*** THIS UNIT CAN NOT
  • BE PICKED UP UNTIL DECEMBER 18th, OWNER WILL USE FOR LOAD OUT"
 

BIN CRANE:

  • 2015 SDL 45’ hyd bin crane w/ 10,000 lb. double winch, hyd. Extending axles,
 

WOOD SPLITTER:

SDL Large wood splitter w/ s/a carrier, gas engine, self-contained hydraulics

 

WELDERS:

  • Miller Trailblazer 301G ACDC portable welder, 10,000watt generator, professional series, powered w/ Onan V2 gas eng., 1080 hrs, mounted on steel skid
  • Miller S-22P-12 wire-feed welder

  • 5 – Lincoln Power Mig 255 C mig welders
  • Thermal Arc 251 fabricator welder
  • Cut Master 52 thermal dynamics professional plasma cutter, on steel stand
  • Thermal Dynamics Professional CutMaster 82 plasma cutter, on steel stand
 

METAL ROLLER:

  • 60” 3-roll flat metal roller, w/ hyd dr, will roll up to 13 gauge metal
 

CUTTING TABLE:

  • Photo Eye oxyacetylene cutting outfit w/ table, rail frame
 

FABRICATING SHOP EQUIPMENT:

  • Custom built 5’ metal shear on steel frame    
  • Hyd hose crimper   
  • Qty of wire feed welder wire  
  • King Canada floor-style drill press   
  • Denbigh floor-style drill press, HD (older unit)
  • Misc bench grinders, hand tools, electrical tools
  • Hyd dr bin anchor bender, approx. 30” metal folding brake, w/ hyd dr
  • Approx 4’x6’ steel welding table
  • Large qty of welding clamps, angle grinders, air tools etc
  • Quick Cut 258 electric hacksaw
  • 10’ hyd light metal brake
  • 4’ steel cutting table, on castors

  • Midland engine lathe w/ 3 jaw chuck, turret, tool holder, all manual
  • Qty of misc cable come-alongs
  • Qty of steel tables w/ vices on castors
  • Misc oxyacetylene outfits

  • Custom built hyd press, self-contained

  • Scotchman 4014 metal worker, angle cutter and punch, and shear

  • Modern horizontal and vertical bandsaw, 10 x 18
  • Material roller
  • Parts washer
  • Mfg Unknown smaller vertical/horizontal bandsaw
  • Qty of misc pipe rollers
  • Custom built angle cutter, hyd dr, self-contained
  • Misc sheet metal clamps
 

OTHER EQUIPMENT:

  • 12’ FEL or forklift-mount dozer blade

  • Older dozer blade, was on Case 1070 w/ single cylinder lift, custom built

  • 5 – 5’x5’ steel scrap bins, 4’ high

  • Approx 36’ material roller deck, all steel construction

  • Premium Efficiency 5HP 575 volt 3 phase elec motor w/ gear reduction drive, ratio 71, mounted on steel frame

  • Landsport 10’ aluminum loading ramps
  • Qty of misc bin ring sections

  • Approx 400 SDL bin anchors, 44”, 4” helix

  • Custom-built mobile scaffold, mounted on 4-wheel farm wagon w/ automotive steering, self-contained hyd, approx. 12’ lift, 10’x12’ deck

  • 5’x8’ steel weight box w/ cement weights, semi-mount for towing, 5th wheel pin

  • Large qty of assorted hyd cylinders
  • HD hyd dr winch

  • Hyd dr U-clamp bender on steel frame

  • Custom built 12’ light metal bender, w/ twin hyd cylinders
 

LIVESTOCK EQUIPMENT:

  • 10 – freestanding wind panels, 4 bar, 24’ w/ 10’ Sakundiak bin sheets
 

INVENTORY:

  • Possibility of some hopper cones

  • Approx 8 skid jigs, single, double and triple, 14’, 15.6’, 18’, 19’
 

PAINT SHOP EQUIPMENT:

  • Titan 640 airless paint sprayer
  • Titan 540 airless paint sprayer, on steel trolley, w/ paint reservoir
 

SHOP EQUIPMENT:

  • Qty of nut and bolt bins
  • Parts shelving units
  • Large qty of nuts, bolts, parts, filters, booster cables, paint, rivet machine, bead blaster, welding helmets
 

MISCELLANEOUS ITEMS:

  • 2 – portable 4’x8’ signs w/ steel frame, 1 w/ single axle carrier wheels

  • 1480 combine axle w/ 2 – 28L-26 tires and rims
  • Large qty of assorted iron
  • Sure-Flame propane-fired construction heater
  • Qty of misc paint
  • Misc scaffolding
  • Steel sawhorses
  • Qty of tractor weights
  • Hyd dr winch w/ orbit motor and tank, *for parts
  • 2 – service station style gas bowsers
  • Steel 3-compartment tanks, approx. 40gal each
  • Qty of iron racks
  • Qty of tires and rims
  • Bin stiffeners
  • Hoses
  • Extension cord
  • L-shaped 100gal steel fuel tank w/ fill-rite 15gal/min HD 12 volt DC pump
  • Assorted “Wide Load” signs, and pilot truck signs
  • Bobcat BG5H, approx. 5000 watt generator
  • Bin dolleys
  • Metal banding machine
  • Hyd bumper jack
  • Approx 20 insulated tarps
 

OFFICE EQUIPMENT:
  • Misc Filing Cabinets etc.
 

The Management and Staff of
Bruce Schapansky Auctioneers
would like to wish our
Clients & Customers all the best
in the New Year.
Thank you for your past patronage.


We look forward to working with you
again in the New Year.

Our Office will be closed for the Holidays from Thursday Dec 20th until Wednesday January 2nd.

If you need assistance during this time call Bruce 306-873-7319, Don 306-921-8952, Barrie 306-921-7732

ONLINE ONLY
CONSIGNMENT AUCTION


Tisdale, Sask


OPENS
Tuesday January 29th
CLOSES
Tuesday February 5th

ANNUAL SPRING CONSIGNMENT AUCTION

Tuesday April 16th, 2019
**TENTATIVE DATE**

Tisdale, Sask

CALL TODAY TO CONSIGN YOUR FARM DISPERSALS TO THIS MASSIVE 1 DAY AUCTION

306-873-5488


FARM AUCTION

Kelvin Schapansky & Terry Berkan
BKS Farms

Strasbourg, Sask

Thursday April 18th, 2019



FARM AUCTION


Mike & Lynn Graf
Dave Graf

Watson, Sask

Saturday April 20th, 2019



FARM AUCTION


Wayne & Diane Drebit
Drebit Farms Ltd.

Clemenceau, Sask

Thursday April 25th, 2019



FARM AUCTION


Jerry & Diane Hrechuk

Elstow, Sask

Saturday April 27th, 2019


FARM AUCTION


Connie Franko &
The Estate of Doug Franko
Franko Farms Inc.

Quill Lake, Sask

Friday May 3rd, 2019



ESTATE FARM AUCTION


Estate of Leonard Langdon

Weekes, Sask

Thursday May 9th, 2019



FARM AUCTION


Glenn Unger

Kandahar, Sask

Thursday July 18th, 2019


 

Click here for results from past auctions

 

PLEASE CLICK HERE TO SEE OUR DRONE VIDEO OF OUR SPRING 2015 AUCTION
ALSO PLEASE LIKE US ON FB!!!


 

SCHAPANSKY BIN MOVERS NOW HAULS MACHINERY!

 

CLICK HERE FOR DETAILS

FARM DISPERSAL

Skene Farms Ltd.
Don Skene

Kinistino, Sask

to be held in conjunction with our annual Spring Auction, Located Hwy #3 east Tisdale SK

Tuesday
April 20th, 2021


   
     
     
     
     
     
     
     
     
     
     
     

Website developed by Ultratech Printing Ltd., Melfort, SK
Maintained by the staff at Bruce Schapansky Auctioneers Inc.
©2012 Bruce Schapansky Auctioneers Inc.

 

 

 

 

Aerial HOME